Dremel 570 1/8" Carbide Grout Removal Bit ID338653

Turn your Dremel rotary tool into a fast, efficient grout removal tool. Our carbide grout removal bit gives you just the right amount of power to clean out grout lines so you can replace damaged tiles or update your grout. 1/8-inch steel shank.

• Seamless controlled cutting
• Works perfectly on both wall and floor grout
• Easily remove both wall and floor grout use with Dremel grout removal attachment
• A high-speed cutter with a 1/8" steel shank
• 30 degree angle for controlled cutting
• Guides 180 degrees apart to keep bit centered

User Tips

• For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
• Do not run in excess of 18,000 rpm. Therefore, do not use with a Single-Speed MultiPro Rotary Tool unless you use the #221 Foot Speed Control.

• BIT DIAMETER INCH: 1/8"
• BIT DIAMETER MM: 3.2 mm
• CONTENTS: 1 Bit
• OVERALL LENGTH: 1.5